Panasonic DH-4UD1, Operating And Installation Instructions

Page: 7 / 32

English
EN7
Temperature setting.
DH-4UDP1 & DH-4UD1
a) The shower temperature can be gradually controlled by pressing either - or + button.
b) Each press of the button will either reduce or increase the temperature by 1 °C.
Continuous press of the button will either continuously reduce or increase the temperature.
Figure 1
CLEANING
FILTER
Water Volume Knob
c) Lowest adjustable temperature is 32 °C.
d) Further press of the button will change the display to "PO" which is power off mode
(Shower temperature will be same as inlet water temperature).
e) Highest adjustable temperature is 45 °C.
f) When the word "MAX" appear at the Power Display a higher temperature is required, reduce the
water fl ow by turning the Water Volume Knob anticlockwise until "MAX" disappear (refer to Figure 1).
g) In case of continuous usage at high temperature setting, water temperature will increase and
it may cause the control device to activate temporarily resulting water temperature to drop.
9. U-Mode setting.
Safe
Warm Cool Hot &
Up Down Cool
Cool
Safe
U-Memory
Hot WarmCool Hot &
Up Down Cool
Cool
Safe
U-Memory
Hot
Warm CoolHot &
Up DownCool
Safe
U-Memory
Press U-Mode
Button
__
+
U-Mode
Pump Set
1
2 3
U-Memory
Control Panel
Press U-Mode
Button
Press U-Mode
Button
Press U-Mode
Button
DH-4UDP1 & DH-4UD1
a) There are three types of U-Mode.
i. Cool Down Mode
ii. Warm Up Mode
iii. Hot & Cool
b) U-Mode operation will start by
press U-Mode button at Control
Panel.
c) The U-Mode function will vary by subsequently
pressing the U-Mode button (U-Mode Cool Down ->
U-Mode Warm Up -> U-Mode Hot & Cool).
d) After select the U-Mode function, Hot & Cool Indicator
will fl ash (approximately 3 second) and selected U-Mode
Indicator will illuminate depending on the selected U-Mode function.
e) Once the U-Mode process starts, Hot & Cool Indicator will fl ash
again.
Note:
While the U-Mode process is running, the display temperature will
remain, while the actual shower temperature will decrease or increase
(depending on the selected U-Mode function).
Warm Cool Hot &
Up Down Cool
Cool
Safe
U-Memory
Hot and Cool
Indicator
Selected U-Mode
Indicator
f) There are few options for each of the U-Mode function.
Please refer to Table below for details.
U-Mode function setup:
Menu Display Indication Setting
Cool Down
Mode
rm Cool Ho
p Down C
W
Cool Cool
< illuminate >
< fl ash >
Temperature
Default Option [1] Option [2] Option [3]
-2 °C -3 °C -4 °C
PO
**Power Off
Time
Default Option [1] Option [2] Option [3]
20 s 10 s 40 s 60 s
Warm Up
Mode
Warm C
Up Do
Hot
< illuminate >
< fl ash >
Temperature
Default Option [1] Option [2]
2 °C 3 °C 4 °C
Time
Default Option [1] Option [2] Option [3]
20 s 10 s 40 s 60 s
Hot & Cool
Mode
ool Hot &
own Cool
ool Hot &
own Cool
< illuminate >
< fl ash >
Temperature
Default Option [1] Option [2] Option [3]
-4 °C -3 °C -2 °C
PO
**Power Off
Time
Default Option [1] Option [2]
Hot: 40 s ;
Cool: 30 s Hot: 30 s ;
Cool: 20 s Hot: 50 s ;
Cool: 40 s