EN14
5.
Piping installation procedure.
Safe
Pump
+
-
U-Mode
Pump
Set
1
2
3
U-Memory
JET PUMP
U-Memory
Main Body
Thread End
Filter Body
Assembly
Shower Hose
Rubber
Packing
Shower
Head
Parts not included
Use fl exible pipe
minimum length 150 mm
Water
Volume Knob
Water Inlet
Water Outlet
Place Rubber Packing between Filter Body Assembly and Flexible Pipe.
Do not use Piping Tape.
Tighten it by Spanner fi rmly.
Place Rubber Packing between Filter Body Assembly and Main Body.
Do not use Piping Tape.
Tighten it by hand fi rmly.
Place Rubber Packing between Shower Hose and Main Body.
Do not use Piping Tape.
Tighten it by hand fi rmly.
Place Rubber Packing between Shower Hose and Shower Head.
Do not use Piping Tape.
Tighten it by hand fi rmly.
The Filter Body Assembly should be placed in the front direction of the Unit.
WARNING
Do not share the inlet or outlet pipe of Home Shower Unit with
other outlets.
The pressure may drop due to water being drawn off at other point.
The shower water temperature may become very hot.
CAUTION
Avoid using dirty water as it may affect heater performance
and other components.
Note:
Make sure no water leaks from pipe connection.
Note:
When glue is used for external piping connection, must wait for the glue
to dry before proceed to test run with water.
6.
How to fi x the Front Plate.
DH-4UDP1 & DH-4UD1
+
-
U-Mode
Pump
Set
1
2
3
U-Memory
JET PUMP
+
-
U-Mode
Pump
Set
1
2
3
U-Memory
JET PUMP
+
-
U-Mode
Pump
Set
1
2
3
U-Memory
JET PUMP
Front Plate
Back
Plate
Press
Screw
Close the Front Plate of the Unit according
to the sequence as illustrated
(Close from top to bottom).
Fix the screw at the bottom of the Unit.
Note:
Do not push the ELB Test Button during fi xing the
Front Plate.
DH-4UP1 & DH-4US1
Off
High
Power Control
ELB
Power Control
Knob
Back Plate
"D-Cut" Position
Make sure the Power Control Knob on Front Plate and it is at
“Off”
position.
Make sure the “D-Cut” position of the VR Shaft are located as shown.
Close the Front Plate of the Unit according to the sequence as
illustrated.
Push in the Power Control Knob until it is fully insert <Power
Control Knob cannot be inserted if Step
and Step
is not done accordingly>.
Fix the Screw at the bottom of the Unit.
Note:
1.
Do not push the ELB Test Button during fi xing
the Front Plate.
2.
Do not apply extreme force to insert the
Power Control Knob during fi xing the Front
Plate because it will damage the switch inside
the
Unit.
Power Control
ELB
High
Off
JET PUMP
Power Control
ELB
High
Off
JET PUMP
Power Control
ELB
High
Off
JET PUMP
Front Plate
Back
Plate
Press
Screw
Press
Summary of Contents for DH-4UD1
Page 30: ...MEMO ...
Page 31: ...MEMO ...
