58
CX-DH801U
31
English
Installation
WARNING
❐
This installation information is designed for professional installers with knowledge of
automobile electrical safety systems and is not intended for non-technical, do-it-yourself
individuals. It does not contain instructions on the electrical installation and avoidance of
potential harm to air bag, anti-theft and ABS braking or other systems necessary to install
this product.
Any attempt to install this product in a motor vehicle by anyone other than a profes-
sional installer could cause damage to the electrical safety systems and could result in
serious personal injury or death.
❐
If your car is equipped with air bag and/or anti-theft systems, specific procedures may
be required for connection and disconnection of the battery to install this product.
Before attempting installation of this electronic component against the manufacturer’s
recommendation, you must contact your car dealer or manufacturer to determine the
required procedure and strictly follow their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED DEPLOY-
MENT OF AIR BAGS OR ACTIVATION OF THE ANTI-THEFT SYSTEM RESULTING IN DAM-
AGE TO THE VEHICLE AND PERSONAL INJURY OR DEATH.
❏
Overview
This product should be installed by a professional. However,
should you decide to install the product against the manu-
facturer’s recommendation, these operating Instructions do
not contain electrical installation instructions. You must con-
tact your car dealer or manufacturer for electrical connection
instructions to avoid possible damage to your electrical safe-
ty systems and resulting injury or death.
(Please refer to
the “WARNING” statement above).
Your next step is to decide where to install the unit. The
instructions in these pages will guide you through the
remaining steps:
¡
Identify and label the car wires.
¡
Connect the car wires to the wires of the power connec-
tor.
¡
Install the unit.
¡
Check the operation of the unit.
If you encounter problems, please consult your nearest pro-
fessional installer.
Before you begin installation, look for the following items
which are packed with your unit.
¡
Warranty Card
…… Fill this out promptly.
¡
Installation Hardware
…… Needed for installation.
Warning:
This product is designed for operation
with a negative grounded 12 V DC battery system. Never
operate this product with other battery systems, espe-
cially a 24 V DC battery system.