- 12 -
Figure 12. Fixing of DEG (degaussing) coil and DAG GND.
DVD Replacement
Note: Observe universal STATIC PRECAUTIONS
when handling the DVD unit.
Replace the DVD unit when it fails (DVD unit is not
shipped with its enclosure). When installing a new
DVD, note the order of disassembly, and save the
hardware. Follow the procedures for A-Board Removal
on page 10. It is necessary to disassemble the plastic
frame that holds the A-Board. It is held by 2 snap tabs
on each side - one at the backside of the A-Board
frame, and one approximately 1.5” apart (inside the
plastic stiffening rib). Gently pull on the tabs to release
each rail from the DVD bracket. See items 10 and 21
on page 9. Then, remove the W-Board located
underneath the DVD that is secured to the DVD case
with 2 screws. Reinstall in reverse order of
disassembling. Reuse hardware and flat cable.
Remove the shipping grounding “plug” from the
underside of the DVD unit. Verify that the ferrite beads
are installed on the cables connecting to the DVD unit.
See Fig. 14 through Fig. 15 (page 13).
Figure 13. Assembly of chassis frame, DVD pack
& P-Board.
Clamper (4 places)
DAG GND
DEG Coil
DAG GND Connector
CRT
Clamper
DEG Coil
Mounting Ear
CRT
CRT Face
30~40mm
DEG Coil
Connector
Detailed side view
IMPORTANT NOTE:
Reuse hardware (screws,
bolts, connectors, etc.) upon
reassembling the Receiver.
DVD
Pack
Main
Chassis
DVD
Bracket
Chassis
Rail (R)
Chassis
Rail (L)
P-Board
珍惜眼前人 搜集整理
QQ:362399998 QQ群:12919880
