Panasonic CS-Z20VKR, Service Manual

Page: 101 / 206

101

Remote Control Receiving Sound
o
Normal Operation  nanoe
TM
X Operation : Beep
o
nanoe
TM
X Operation  Normal Operation : Beep
o
Stop  nanoe
TM
X individual Operation : Beep
o
nanoe
TM
X individual Operation  Stop : Long Beep

Power failure
o
During nanoe
TM
X individual operation, if power failure occurs, after power resumes, nanoe
TM
X individual
operation resumes immediately.
o
During combination operation, if power failure occurs, after power resumes, combination operation resume
immediately.

nanoe
TM
X check mode
o
To enable nanoe
TM
X check mode, during nanoe
TM
X operation ON:
Normal display mode
Transmit
“NANOE™ X CHECK” code
Press SW (t ≥ 0 secs)
When SW pressed continuously for t ≥ 5 secs to enter service zone
and press SW’s to choose function 57
SET
o
During nanoe
TM
X check mode, H67 is judged when disconnection detected. Timer LED blinks.

nanoe
TM
X Abnormal Detection
o
Disconnection Abnormality
 Abnormal detection condition

Start from 1 sec after nanoe
TM
X power ON, 6 secs has passed and in this 6 secs period, abnormal
signal is detected continuously for 5.9 secs.
 Action after abnormal detection condition fulfilled

Disconnection co1, nanoe
TM
X power OFF for 5 minutes and then restart. However,
according to action mode and disconnection counter, below will be implemented:
o
During nanoe
TM
X Check Mode: Disconnection abnormality will judged when disconnection
counter ≥ 1. Abnormal code: H67 will memorized in EEPROM, Timer LED blinking and
nanoe
TM
X LED Off.
o
Other Than Above: Disconnection abnormality will judged when disconnection counter ≥ 3.
Abnormal code: H67 will memorized in EEPROM and nanoe
TM
X LED OFF, Timer LED not
blinking.
 Disconnection counters clear condition >

Disconnection counter will be cleared when operation stop. (Not nanoe
TM
X Check Mode)
o
nanoe
TM
X Discharge Abnormality
 Abnormal detection condition

After 30 minutes nanoe
TM
X power ON, abnormal signal is being detected continuously for 5s.
 Action after abnormal detection condition fulfilled

Abnormal discharge c1, nanoe
TM
X power OFF for 30 minutes and then restart. When
abnormal discharge counter ≥ 12, abnormal code: H67 in analyze area (Area where abnormal code
not displayed) will be memorized.
 Abnormal discharge counters clear condition

Discharge counter will be cleared when operation become normal for 50 mins above or when
operations stop.