Panasonic CS-S9JKQ, Operating Instructions Manual

Page: 5 / 16

5
ENGLISH
TO SELECT FAN SPEED
(5 OPTIONS)
• For AUTO, the indoor fan speed is automatically adjusted
according to the operation mode.
TO ADJUST VERTICAL AIRFLOW
DIRECTION (5 OPTIONS)
• Keeps the room ventilated.
• If AUTO is set, the louvers swing up/down automatically.
TO ENJOY CLEAN &
FRESH AIR
• Generates negative ions to produce fresh air effect and
attract dust which will then be captured at the positively
charged e-ion fi lters.
TO MONITOR AIR
QUALITY
Indicator Air Quality
Blue Clean
Orange Moderate
Red Dirty
PATROL SENSOR
• Detects air quality; e-ion
operation activates when air
quality is at dirty level.
• Regardless of air quality, to maintain air freshness e-ion
activates automatically (PATROL SENSOR indicator turn
red) when:
- 2 minutes after the unit is on, or
- exceeds 4 hours at clean level.
• Fan speed is adjusted automatically.
TO IMPROVE HUMIDITY
AND MOISTURE LEVEL
MILD DRY COOLING
• This operation reduces air dryness and provides you with
a comfortable living environment.
• When vertical air fl ow direction is set to AUTO, it stops at
lower position to avoid cold air contact. However, you can
adjust the louver direction manually.
TO ENJOY QUIET
ENVIRONMENT
QUIET
• This operation reduces air fl ow noise.
TO ACHIEVE
TEMPERATURE QUICKLY
POWERFUL
• This operation will stop automatically after 4 hours.
• , , and can be activated
in all modes and can be cancelled by pressing the
respective button again.
• only can be activated in COOL mode and can
be cancelled by pressing the button again.
• and or , and can
not be selected at the same time.
• and can be activated even when the unit
is turned off. In this condition, fan speed and air swing
can not be adjusted.
TO SET THE TIMER TO SET THE TIMER
• To turn ON or OFF the unit at a preset time.
TIMER
Select ON or
OFF timer.
Set the time. Confi rm.
• To cancel ON or OFF timer, press or then
press .
• When ON Timer is set, the unit may start earlier (up
to 15 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control Preparation at back
cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
.
OPTIONAL SETTINGS OPTIONAL SETTINGS
Patrol starts automatically with the unit
switched on with
.
Press and hold for 5 seconds, then release
to disable or restore this setting.
Press and hold for 5 seconds to dim or
restore the unit’s indicator brightness.
Press and hold for approximately 10
seconds to show temperature setting in
°C or °F.
Press and hold for approximately 5 seconds
to show 12-hour (am/pm) or 24-hour time
indication.
Press to restore the remote control’s default
setting.
,
Not used in normal operations.
Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.