Panasonic CS-ME10EB1E, Operating Instructions Manual, Page: 5 / 12

ENGLISH
5
CANCEL
/&&
4)-%2
/.
4)-%2
&!.
30%%$
!54/
(%!4
$29
#//,
/&&
MODE
TIMER
ON
1 2 3
OFF
CLOCK RESET
SET
POWERFUL
FAN SPEED
AIR SWING
OFF/ON
QUIET
AUTO
MANUAL
CHECK
INVERTER
2 2 2 2
/ /O O
AI R SW W IN NG
$29 (%!4
#//,
!54/
N
Operation Details
Auto, Heat, Cool, Dr y
• The unit will automatically select
the operation mode according
to the setting, outdoor and room
temperature. During operation mode
selection, power indicator blinks. For
every 3 hours, the operation mode is
reselected.
• Enables you to enjoy the cooling
effect at your preferred setting
temperature.
• Enables you to set the desired
temperature at low fan speed which
provides you with the dehumidifying
surroundings.
Troubleshooting
AUTO - Automatic Operation
COOL - Cooling Operation
DRY - Soft Dry Operation
HOW TO OPERATE
L
Powerful and Quiet operations could be activated in all
operation modes.
L
Press
OFF/ON
button again to stop the operation.
L
Power indicator blinks. °
The operating mode is different from other indoor unit.
L
Operation delayed for a few minutes after restart.
° This is a normal self protection control.
L
Sounds like water flowing during operation.
° Caused by refrigerant flow inside.
L
Cracking sound can be heard during operations.
° Panel expanding/contracting due to change in temperature.
L
Occasionally knocking sound is heard.
° Switching over of refrigerant gas in the system during defrosting and at
the end of operations.
L
Heat is obtained from outdoor air to warm up the room. Use additional heater when outdoor ambient temperature is low.
Hint
• Enables you to enjoy the warming
effect at your preferred setting
temperature.
• For cold air prevention, air might
not blow out immediately and power
indicator blinks when operation
starts.
• Also operates in defrost mode
(maximum 12 minutes) where by the
power indicator blinks. The melted
frost is drained at outdoor unit and
indoor fan is stopped.
HEAT - Heating Operation
1
Select the
desired
operation.
3
Set the
temperature.
(16°C ~ 30°C)
Start the
operation.
2