Panasonic CS-ME 7CKPGCS-ME10CKPG, Operating Instructions Manual, Page: 15 / 220

ENGLISH
15
Timer setting / Sleep Timer Mode
Setting the Timer
Once the appointed time is set, the unit will start to
operate automatically everyday on the set time. The
timer operates on a combination of 2 settings: “TIMER
ON” and “TIMER OFF”. You must confirm and
synchronize it to the current time. The timer will not
operate when the time display is blinking.
■
To cancel
operations
●
The indoor unit's timer lamp remains on even after
operation has been stopped by the OFF Timer.
●
When the timer is set, the current time indication will be off.
●
When the timer is off and the operation has stopped, the
timer lamp on the indoor unit remains on.
(The timer lamp will only be off when the timer cancelation
is selected)
●
When the timer is on, the operation will start on the time
set. It is advisable to set it to operate earlier than the desired
time to allow it to reach the set temperature. (Maximum 1
hour before)
●
When this timer setting mode is used concurrently with the
sleep timer mode, the sleep timer mode will be given the
priority. (After the sleep timer mode has stopped operating,
the appointed time will again be displayed)
Sleep timer Mode operation
It will stop the unit's operations after the preset
time.
IN OPERATIONS
Press
Remaining time being displayed
(1 hour time blocks)
●
When the 5 hour or 7 hour modes are selected, the set
temperature will change as follows.
Select the appropriate
timer using
or
buttons then press
Sleep timer mode
off button
1
Select
or
Remote control
display panel
2
To select the appointed
time
●
Blocks of 10 minutes
are shown each time it is pressed.
Continuously pressing either button will fast
forward or reverse the displayed time
blocks.
●
12 midnight will be displayed as .
3
Press
Timer lamp (Orange)
Timer setting
button
1 2 3 7 5
Remote control
display panel
●
Continuously pressing
Select the time while the time blocks
changes in the display.
(Cancel)
Timer lamp (Orange)
COOLING • DRY
after 3 hours; increase by approximately 2°C
HEATING
after 4 hours; decrease by approximately 4°C
Recommended to use this mode:
●
Saving on electricity during sleep is required.
●
To prevent wastage of electricity, use sleep mode when
sleeping or Timer when going out.