background image

15

English

Troubleshooting

Cleaning instructions / 

T

roubleshooting

The following symptoms do not indicate malfunction.

Symptom

Cause

Mist emerges from indoor unit.

• Condensation effect due to cooling process.

Water 

fl

 owing sound during operation.

• Refrigerant 

fl

 ow inside the unit.

The room has a peculiar odour.

• This may be due to damp smell emitted by the wall, 

carpet, furniture or clothing.

Indoor fan stops occasionally during automatic 
fan speed setting.

• This helps to remove the surrounding odour.

Operation is delayed a few minutes after 
restarting.

• The delay is a protection to the unit’s compressor.

Outdoor unit emits water/steam.

• Condensation or evaporation occurs on pipes.

TIMER indicator is always on.

• The timer setting repeats daily once set.

Cracking sound during operation.

• Changes of temperature caused the expansion/

contraction of the unit.

Discoloration of some plastic parts.

• Discoloration is subject to material types used in plastic 

parts, accelerated when exposed to heat, sun light, UV 
light, or environmental factor.

Dust may have collected around the front
panel, grilles and wall surrounding the unit 
after extended use.

• The dust accumulation is due to air puri

fi

 cation effect of 

negative ions from nanoe-G. Remove the dust regularly 
with a clean dampened cloth.

Check the following before calling for servicing.

Symptom

Check

Operation in COOL mode is not working 
ef

fi

 ciently.

• Set the temperature correctly.
• Close all doors and windows.
• Clean or replace the 

fi

 lters.

• Clear any obstruction at the air inlet and air outlet 

vents.

Noisy during operation.

• Check if the unit has been installed at an incline.
• Close the front panel properly.

Remote control does not work.
(Display is dim or transmission signal is weak.)

• Insert the batteries correctly.
• Replace weak batteries.

The unit does not work.

• Check if the circuit breaker is tripped.
• Check if timers have been set.

The unit does not receive the signal from the 
remote control.

• Make sure the receiver is not obstructed.
• Certain 

fl

 uorescent lights may interfere with signal 

transmitter. Please consult authorised dealer.

Water splashing sound at outdoor unit during 
operation.

• This is due to drainage method is opted for maximise 

performance. Please consult authorised dealer to alter 
drainage method.

NON SERVICEABLE CRITERIAS

TURN OFF POWER SUPPLY AND UNPLUG then please consult authorised dealer under the following 
conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the remote 

control.

• Water leaks from Indoor unit.

• Circuit breaker switches off frequently.
• Power cord becomes unnaturally warm.
• Switches or buttons are not functioning properly.
• The unit stops and the TIMER indicator blinks

(insuf

fi

 cient refrigerant detected).

Summary of Contents for CS-LV7SKA

















Reviews: