67
CQ-VD7200U
58
E
N
G
L
I
S
H
(a) Using the Rear Support Strap
o
(b) Using the Rubber Pad
r
r
Rubber Pad
t
Mounting Bolt (M5)
Display Unit
Bracket
(On car)
u
Washer
Assembling
Hex. Bolt
(M5 x 10 mm)*1
i
Washer Assembling Hex.
Bolt (M6 x 20 mm)
Fire wall of car
Drill a hole 6.5 to 7 mm
in diameter.
y
Flange Nut
(M6)
Display Unit
o
Rear Support Strap
Method for Fixing the Rear of the Unit
q
Push the right and left clamp plates outward, one at a time, and pull the display unit toward yourself.
w
After removing the right and left clamp plates, pull the unit with both hands till it comes off.
Push here to
remove the
clamp plates.
q
w
To Remove the Display Unit
*1: Use M5 x 8 mm size bolt (optional) if bolts other than
the supplied ones are to be used.
66
CQ-VD7200U
57
E
N
G
L
I
S
H
Installation Guide
(continued)
1
3
5
6
2
4
❏
Installation Procedures
(When using Mounting Collar
w
)
Mounting the Display Unit
Insert the Mounting Collar
w
into the dashboard, and
bend the mounting tabs out with a screwdriver.
Establish the rear connection of the unit.
After fixing Power Connector
@6
and Display Unit/Hide-
away Unit Connecting Cord
@9
, fix the rear of the unit to
the car body by either method (a) or (b) shown at right.
Insert Trim Plate
q
.
After installation
reconnect the negative
(–) battery terminal.
Attach the Mounting Springs
e
to the display unit.
@6
Power Connector
@9
Display Unit/Hide-away
Unit Connecting Cord
t
Mounting Bolt (M5)
e
Mounting Spring
!1
Flat-Head Screw
(M5 x 6 mm)
Note:
The car model,
installation conditions and
combination of the units
used may impose some
restrictions on opening
and closing the monitor as
well as on the angle and
position to which the
monitor can be adjusted.
Fastening the Mounting Collar
The tabs to bent vary depending on the car. Bend them
with a screwdriver to fasten the Mounting Collar
w
securely in the dashboard.
w
Mounting Collar
Dashboard
Tab
Insert the unit into Mounting Collar
w
Secure the clamp plate of Mounting Collar
w
to the hook of Mounting Spring
e
.
Clamp plate
