Panasonic CQ-R235W, Manual

Page: 38 / 48

20
CQ-R235W
E
N
G
L
I
S
H
18
Electrical Connection
Cautions:
¡ This product is designed to operate of a 12 volt, negative ground battery system.
¡ To prevent damage to the unit, be sure to follow the connection diagram below.
¡ Remove approx. 5 mm of protective covering from the ends of the leads before connecting.
¡
Do not insert the power connector into the unit until the wiring is completed.
¡ Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables
and keep cable terminals free from touching any metal parts.
(–) (+) (–) (+) (–) (+) (–) (+)
Panasonic Panasonic
Antenna
y
Power Connector
Preamp out Connector
(Rear)
(Yellow)
Fuse(15 A) (Red)
(Black)
(Black)
(Dark blue)
(Violet w/black stripe)
Speaker Lead
(Gray w/black stripe)
(White w/black
stripe)
(White) (Gray) (Green w/black
stripe)
(Green)
(Violet)
Left Speaker
(Front)
Left Speaker
(Rear) Right Speaker
(Front) Right Speaker
(Rear)
Battery Lead
To the car battery, continuous
+12V DC
Power Lead (ACC or IGN)
To ACC power, +12V DC
Ground Lead
To a clean, bare metallic
part of the car chassis
Motor Antenna
Relay Control
moves antenna up and down
DIN Cord
BATTERY15A
ACC
REAR SP FRONT SP
CD Changer
Control Connector
CH
•
C-IN
Resistor (1 k
Ω
)
(L) (White)
(R) (Red)
Cassette Receiver
CQ-R235W
Extension Cord
(DIN/BATT/RCA/GND)
(Black)
CD Changer
CX-DP88N
Ground Lead
To a clean, bare metallic
part of the car chassis
(Yellow)
RCA Cord
Battery Lead
To the car battery,
cont12V DC
Be sure to connect to a well
grounded metallic part of your
car because noises or
troubles may occur.
(R)(Red)
(L)(White)
Fuse (3A)
CD Changer Input Cord
¡ This unit can be connected to an optional CD changer (CX-DP88N etc.). For details consult your nearest
authorized Panasonic dealers.
¡ For connection to a CD changer, refer to the operating instructions of the CD Changer (CX-DP88N etc.).