Preparation
English
CQ-C8351N/C8301N/C7301N
11
10
Preparation
CQ-C8351N/C8301N/C7301N
Note:
¡
Adjust the clock when “NO CT” appears on the dis-
play.
¡
When a broadcast of FM Radio Data System is
received, the clock is put right automatically by the
Clock Time service. (
a
page 20)
1
Press
[MENU]
to display the menu
display.
For using the remote control, hold down
[SEL]
(MENU)
for 2 sec. or more.
2
Press
[
]
]
or
[
[
]
to display the
DISPLAY menu.
3
Press
[
{
]
to select “CLOCK ADJ”.
4
Press
[BAND]
(
SET
) to confirm the
display.
5
Adjust the setting value.
[
[
]
: Adjusting minutes
[
]
]
: Adjusting hours
[
}
]
: Forward
[
{
]
: Backward
6
Press
[BAND]
(
SET
) to confirm the
adjustment.
Note:
For cancellation of clock adjustment, press
[DISP]
.
7
Press
[MENU]
.
For using the remote control, hold down
[SEL]
(MENU)
for 2 sec. or more.
The demonstration message appears for first use.
1
Set your car's ignition switch to the ACC
or On position.
2
Press
[SRC]
(
PWR: POWER
).
The demonstration screen appears.
3
Press
[DISP: DISPLAY]
.
The demonstration screen is cancelled, and no more
appears.
Note:
If you would like to turn on the power and make
the demonstration message appear, hold down
[SRC]
(
PWR: POWER
) for 4 sec. or more. (at ACC on
setting)
You may need to set the following depending on the
devices to be connected.
Using Subwoofer
¡
Subwoofer level adjustment (
a
page 34)
¡
Subwoofer low pass filter (
a
page 34)
The following functions are activated when the Security
Function is ON. (
a
page 35)
¡
The security indicator lights up when removing the
face plate.
¡
The alarm sounds and the message appears on the
screen to warn you to remove the face plate at ACC
off.
Security Indicator
AF
SRC
PTY
CQ-C8301N
SQ
TA
First T
ime Power On
(DEMONSTRATION)
Remote Control Preparation
Security Function
Setting
Other Settings
Clock adjustment
(CLOCK ADJ: CLOCK ADJUSTMENT)
Warning
Keep batteries and insulation film out of reach of
infants. If an infant ingests a battery, please seek
immediate medical attention.
Cautions
¡
Remove and dispose of an old battery immediately.
¡
Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.
¡
Follow local regulations when disposing of a battery.
¡
Improper use of a battery may cause overheating, an
explosion or ignition, resulting in injury or a fire.
Note:
Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
Battery Life: Approximately 6 months under normal use
(at room temperature)
Preparation Before Initial Use
Pull the insulation film out
from the backside of
remote control gently.
Battery Replacement
q
w
q
Remove the battery holder
with the remote control unit
placed on a flat surface.
q
Stick your thumbnail into
the groove, and push the
holder in the direction of
the arrow, and at the
same time.
w
Pull it out in the direction
of the arrow using a
tough pointed object.
2
3
w
Put a battery in the case
with (+) side facing up.
e
Put the case back.
Tough pointed object
Back side
ACC Setting
OFF
ACC
IGN
For a ACC-equipped car, select ON. (
a
page 35) The
following functions are available. (default: off)
¡
The power is turned on automatically when inserting a
disc or magazine.
¡
The clock can be displayed even if the power is off.
(
a
page 15)
SRC
Insulation film
Caution
Be sure to select OFF when your car has no
ACC position in the ignition switch. Failure
to do this could cause the battery to go
dead.
