4. Disconnect motor lead wire.
8.6. Floor shelf and/or moving
antenna
1. Insert a philips type screwdriver or equivalent approx. 2”
(5cm) in shaft length in the hole of left side oven wall as
shown in Figure.
2. Carefully lift up the floor shelf by using the screwdriver until
the floor shelf is lifted up over the level of oven opening
front.
3. Remove the floor shelf by lifting it up from oven front.
To replace moving antenna.
4. Remove the moving antenna by simply lifting it up off the
stirrer motor shaft.
NOTE:
When replacing the moving antenna, make sure the
plastic stirrer spacers are correctly in place.
8.7. Convection Heater
1. Remove 10 screws holding back panel.
2. Disconnect heater and circulation fan motor lead wire
connector.
3. Remove a screw holding exhaust guide.
4. Remove 5 screws holding heater panel.
5. Slide up heater panel unit to release from oven cavity.
6. Remove 6 screws holding heater support and heater.
NOTE:
After oven has been used the internal surface of the
cavity may become permanently dark.
Please note this condition is normal and it does not
affect ovens performance.
19
NE-C1153 / NE-C1153C
Summary of Contents for Combi Wave NE-C1153
