28
The following settings are necessary to prepare the CD-ROM pack for use:
To use the CD-ROM pack in the MS-DOS mode, configure the drive following the steps below
after performing the above steps 1 ~ 3.
If the steps listed below are performed without
completing steps 1 ~ 3 above first, the drive will not operate properly.
1
Click the [Start] button then select [Shut Down].
2
Select [Restart in MS-DOS mode] and click [OK].
3
Open the "CONFIG.SYS" file for editing by issuing the following commands:
cd \
Enter
edit config.sys
Enter
4
Move the cursor to the line containing "ATAPICD.SYS" and delete the characters "rem" at
the beginning of the line. (Deleting "rem" causes the item to become valid.)
DEVICEHIGH=C:\WINDOWS\COMMAND\ATAPICD.SYS /D:MSCD000
(If this line is missing, add it.)
5
Press
Alt
+
F
, then
S
to save the file. Then press
Alt
+
F
, then
X
to exit
the Edit program.
6
Follow the same steps to edit the "AUTOEXEC.BAT" file.
edit autoexec.bat
Enter
7
Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem" at
the beginning of the line. (Deleting "rem" causes the item to become valid.)
LOADHIGH C:\WINDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
8
Press
Alt
+
F
, then
S
to save the file. Then press
Alt
+
F
, then
X
to exit
the Edit program.
9
Restart the computer.
1
Add the check mark for [DMA] in [Start] - [Settings] - [Control Panel] - [System] - [Device Man-
ager] - [CDROM] - [TEAC CD-224E] - [Settings].
2
Set [L:] for both [Start drive letter] and [End drive letter] in [Reserved drive letters].
3
At the [System Properties], press [Close]. The display will ask you to restart Windows, then
press [Yes].
If the CD-ROM pack has not been accessed within 30 seconds, the drive motor will automati-
cally shut down to reduce the power consumption. When the CD-ROM pack is accessed once
again, the power of the drive motor is turned on. However, approximately 30 seconds are re-
quired until data is actually read from the CD.
Using a Multimedia Pocket Device
Software Preparation (first time only)
[Removable Disk (A:)] is displayed in [My Computer], but access is not possible. Select
[Cancel].
If the vibration of the CD-ROM drive is excessive, set the [CD-ROM Drive Speed] to [Low] in
the Setup Utility.
NOTE
Using the CD-ROM pack in the MS-DOS mode
Power-saving mode
