– 19 –
Installation work
Installation
(Be sure to ask your dealer to install the unit.)
2.
Attaching the tilting arm
Attach the tilting arm to the pan-tilt head using the four tilting arm fixing screws
(M4
C
12 mm) supplied.
p
Attach the tilting arm to the pan-tilt head in the direction shown in the figure below.
p
Attach the guide pin and camera mounting screws to the camera mounting plate
on the positions as shown in the figure below.
p
Tighten up the guide pin using a slot-head screwdriver.
For installation on the ceiling
For stand-alone installation
Tilting arm fixing
screws
Guide
screws
Camera
mounting plate
Tilting arm
Camera mounting
screws
Guide pin
Guide pin
Camera mounting
screws
Warning
Be absolutely sure to use the fixing screws provided with the unit.
Use of any other screws may cause the tilting arm to fall out of position or a load to be applied
to the rotation operation in the tilting direction, possibly causing trouble or triggering the
establishment of one of the safe modes.
Tighten the fixing screws using the clamping torque below, and check that there is no play in the
tilting arm.
Attaching the plate and arm
Clamping torque
p
Tilting arm fixing screws
p
Guide screws
1.5 N
•
m (15 kgf
•
cm)
