Panasonic AW-RP50, Quick Start Manual

Page: 4 / 14

4. By [5] AUTO SET IP setting, execute the automatic assignment of IP addresses. (RENEW IP ADR)
①
In the state of the above-mentioned 3.-
②
, turn F1 dial to select [5] AUTO SET IP.
②
Press F1 dial to make [RENEW IP ADR] appear on the lower half of the LCD screen.
* If it does not appear, turn F2 dial to make [RENEW IP ADR] appear.
③
While [RENEW IP ADR] is displayed, press F2 dial. The number of units that AW-RP50 has newly detected
and the number of units that it currently manages (all the remote cameras and switchers) will be displayed on
the upper half of the LCD screen. (*2)
④
[NO] will be displayed on the lower half of the LCD screen. So, turn F2 dial to select [YES] and then press F2
dial.
⑤
When [COMPLETE] is displayed on the lower half of the LCD screen, the setting-up is completed.
(*2) The cameras (C) and switchers (S) that AW-RP50 manages are displayed as follows.
After setting up, LED buttons 1 – 3 at <CAMERA STATUS / SELECTION> on the AW-RP50 operation panel light up
in a few seconds according to the camera’s power status. If a camera is in STANDBY mode (power OFF: factory
default), it lights up in orange. If in POWER ON mode (power ON), it lights up in green.
* When a camera is in STANDBY mode, the Power-ON operation needs to be done.
For this operation, please refer to “3. Turn
AW-XXXX
on” of the Manual
【
Controlling
AW-XXXX
Camera
via AW-RP50 Controller
】
.
(AW-RP50: CAMERA STATUS/SELECTION Area)
[1]CAMERA CTL
MENU ON
⇒
Select [10]
[5]AUTO SET IP
1
．
AUTO SET
RENEW IP ADR
Turn F1
Press
C:003/003 S:1/1
NO↓
C:003/003 S:1/1
YES↓
C:003/003 S:1/1
COMPLETE
Turn F2
Press F2
Press F2
②
Currently managed c
①
③
Newly detected switchers
④
Currently managed swi
③
① ②
③ ④
C:003/003 S:1/1
①
Newly detected cameras
① ② ③ ④
After setting up, this lights up
according to the camera’s
power status.