Panasonic AW-RP50, Quick Start Manual

Page: 14 / 14

(*) Function to memorize the camera’s direction and zoom position in switching to STANDBY mode
【
Setting Procedure
】
·
Operate the controller to aim the camera at the desired position and adjust its zoom position.
·
Switch the power of
AW-XXXX
to STANDBY mode (power OFF).
★
The camera will memorize the position specified at the step
①
and turn backwards. (Status lamp: Orange)
·
Switch the camera’s power back to POWER ON mode (power ON).
★
After its default setting motion, the camera will turn to the position specified at the step
①
. (Status lamp:
Green)
Setting will be completed by the above steps.
If the power supply is cut without switching to STANDBY mode, this setting will not be applied to the POWER ON
preset.
Once the POWER ON preset is set, instead of switching the camera to STANDBY mode, turn it ON/OFF by
starting/stopping its power supply. The camera will always boot up in a position specified at the step
①
of the
above-mentioned
【
Setting Procedure
】
.
* Power ON/OFF of
AW-XXXX
can be changed via the controllers
below. For operating each controller, please refer to the following
Manuals.
(Controller:
- AW-RP50:
- AW-RM50:
- PC:
Manual)
【
Controlling
AW-XXXX
Camera via AW-RP50 Controller
】
【
Controlling
AW-XXXX
Camera via AW-RM50 Wireless
Remote
】 【
Controlling
AW-XXXX
Camera via PC
】
Booting Up Camera in Specified Position: POWER ON Preset Function (*)