6 (E)
ENGLISH
Mounting
7
Install the board securely using the screws (B)
and 3 screws (C).
(At this stage, install the cable clamp as well.)
Screws (B)
Screws (C)
Cable clamp
8
Tighten the 6 screws (A) for the upper panel
cover securely.
Screws (A)
9
After attaching the required cables, insert the power connector and turn the power on.
For details on the setting and operating procedures, refer to the operating instructions of the AV-HS300G.
If the HD analog board has been connected properly, “ANLG” will appear at the OPT item on the
AV-HS300G ’s SETUP/STATS menu (5/5).
STATS
15/15
ALM
NO
OPT
ANLG
VER
1.00
In order for the analog HD component signals to take effect, select “ANLG” (analog HD component) in the
MODE item setting for each of the input channels (IN to IN5) from the AV-HS300G ’s SETUP/IN-5 menu
(/5). Analog HD component signals and SDI signals cannot be used at the same time in the same input
channel.
Additionally, the gain of the input signals is set using the GAIN item.(The gain can be set within the
30-step range, and the setting will result in changes of
dB. The amount by which the gain changes per
step is not the same for each step.)
SDI
IN2
IN3
IN4
IN5
IN1-5
1/15
SIG
IN1
MODE
ANLG
GAIN
-30—30
-
Removal procedure
Remove the HD analog board by following the procedures for mounting it in reverse.
