70
Remove the wiring between Remote controller
and Tank Unit terminal.
Mounting The Remote
11.1.7.4
Controller
For exposed type
Preparation:
Make 2 holes for screws using a driver.
For embedded type
Preparation:
Make 2 holes for screws using a driver.
Replace The Remote Controller
11.1.7.5
Cover
Replace the existing Remote controller cover with
Remote controller cover to close the hole left after
remove the Remote controller.
1 Release the Remote controller cover’s hooks
from behind the Front Plate.
Disconnect the
Remote controller
wiring
Claw
(2 places)
UP
Cut here with
a nipper and
remove the burr
with a file.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Hole for screw
Screw
(field supply)
Claw (2 places)
Pass through
the hole
Bottom case
(Back side)
Top case
(Back side)
Remote controller terminal board
Remove the coating. Approx. 6 mm
Remove the sheath. Approx. 180 mm.
Make sure the wiring connection is in the
correct direction.
Clamper
(field supply)
Claw (2 places)
Wall to which
the remote
controller
fixed
is
Mount the bottom case to
the wall.
Connect the remote control
wiring
•
Arrange the wires along the groove
of the case.
UP
Avoid the wire
being caught.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Hole for
screw
Screw
(field supply)
Claw (2 places)
Bottom case
(Back side)
Top case
(Back side)
Remote controller
terminal board
Remove the coating.
Approx. 6 mm
Make sure the wiring
connection is in the correct
direction.
Claw (2 places)
Mount the bottom case
to the wall.
•
Pass the wire through the hole
in the centre of the bottom case.
Connect the remote
control wiring
Front Plate
Hook (6 places)
Existing Remote
controller cover
