E-10
EN
G
L
IS
H
Installation
(continue)
To Mount the P2 drive in a Personal Computer 5-inch Bay
1
Turn OFF the personal computer’s power.
2
Undo the six screws and remove the cover.
3
Mount the P2 drive in a 5-inch bay on the
personal computer. Use the screws supplied
with the P2 drive for mounting.
Please refer to your computer’s
instruction manual for guidance in
mounting to 5-inch bay drives.
<Notes>
z
The P2 drive may not be able to be
fastened securely in some types of
personal computers.
z
If all 5-inch bays are occupied, you will
need to remove one of the built-in drives to
make room for the P2 drive.
z
The P2 drive should be used in a personal
computer whose design allows the front
panel of the Drive to be manipulated.
4
Plug a USB 2.0 cable B connector into the
USB connector on the P2 drive. then plug the
other end of the USB 2.0 cable into the USB
2.0 port on the personal computer.
<Note>
USB 2.0 connector pinouts vary according to
the type of motherboard type. Check your
computerís instruction manual before
purchasing a commercially available USB
2.0 cable (shielded).
5
Connect the P2 drive to the internal power
cable (4 pins) of the personal computer.
U
S
B 2.0
DC IN 16V
DC IN 12V
IEEE 1
3
94
b
Holes for securing the screws
(the other side is the same.)
USB 2.0 connector
U
S
B 2.0
DC IN 16V
DC IN 12V
IEEE 1
3
94
b
U
S
B 2.0
DC IN 16V
DC IN 12V
IEEE 1
3
94
b
Power cable
P_AJ-PCD20.book 10 ページ ２００６年６月２８日 水曜日 午前９時４９分
