Chapter 5 Preparation
60
5-1-2 Using an AC power supply
When the AJ-B75 AC adapter made by Panasonic is
used
1
Connect the DC OUT connector on the AJ-B75 AC
adapter to the DC IN socket on the unit.
2
Set the power of the AC adapter to ON.
3
Set the unit’s power switch to ON.
When using an external power supply other than the AJ-
B75 AC adapter, check the pin signals of its external DC
input connector and use the polarities correctly.
Sup12V power to the GND terminal by mistake
may give rise to ignition, resulting in a fire, or it may cause
injury.
<Notes>
≥
Power from the AC adapter takes precedence when
both a battery pack and AC adapter have been
connected. It is also possible to attach/remove a
battery while the AC adapter is being used.
≥
When using the AC adapter, be absolutely sure to first
set the power of the AC adapter to ON and then set the
unit’s power switch to ON.
If the power is turned on in the reverse sequence, the
output voltage of the AC adapter will rise gradually, and
the unit may malfunction as a result.
Pin no.
Signal
1
GND
2, 3
–
4
+12V
1
2
3
4
External DC input socket
DC IN socket
AC adapter
AJ-B75 (optional accessory)
5-2 Attaching the lens and performing
the flange back and white shading
adjustments
Attaching the lens
1
Raise the lever for securing the lens, and detach the
mount cap.
Lever for
securing the lens
Mount cap
Mark
2
Align the center mark of the lens with the groove in the
top center of the lens mount, and attach the lens.
3
Push down the lever for securing the lens to secure the
lens.
01.AJ-HDX400E(VQT0P57)E 05.1.20 15:50 ページ60
