Panasonic AFPE224300, User Manual

Page: 112 / 229

11-14
FP-e (A: Available, N/A: Not available)
Register
No.
Matsushita
IEC
Name Descriptions
Read
-ing
Writ
-ing
DT9020
%MW5.9020
Not used
-
DT9021
%MW5.9021
Not used
-
N/A N/A
DT9022
%MW5.9022
Scan time (current
value)
Note)
The current scan time is stored here. Scan time
is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1 ms
Example: K50 indicates 5 ms.
DT9023
%MW5.9023
Scan time
(minimum value)
Note)
The minimum scan time is stored here. Scan
time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1 ms
Example: K50 indicates 5 ms.
DT9024
%MW5.9024
Scan time
(maximum value)
Note)
The maximum scan time is stored here. The
scan time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1 ms
Example: K125 indicates 12.5 ms.
DT9025
%MW5.9025
Mask condition
monitoring register
for interrupts
The mask conditions of interrupts using the
instruction can be stored here. Monitor using
binary display.
A N/A
DT9026
%MW5.9026
Not used - N/A N/A
DT9027
%MW5.9027
Periodical interrupt
interval (INT24)
The value set by the ICTL instruction is stored.
K0: periodical interrupt is not used.
K1 to K3000: 0.5ms to 1.5s or 10ms to 30s
A N/A
DT9028
%MW5.9028
Not used
-
DT9029
%MW5.9029
Not used
-
N/A N/A
DT9030
%MW5.9030
Message 0
DT9031
%MW5.9031
Message 1
DT9032
%MW5.9032
Message 2
DT9033
%MW5.9033
Message 3
DT9034
%MW5.9034
Message 4
DT9035
%MW5.9035
Message 5
The contents of the specified message (Data
lenght) are stored in these special data registers
when F149 (MSG) instruction is executed.
A N/A
Note) Scan time display is only possible in RUN mode and shows the operation cycle time. (in PROG
mode, the scan time for the operation is not displayed.) The maximum and minimum values are
cleared each time the mode is switched from RUN to PROG.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com