Panasonic 65PX600U - 65" Plasma TV, Operating Instructions Manual

Page: 22 / 63

42 43
Advanced
Operating Peripheral Equipment
Using
T
imer
Menu
Picture
Audio
Lock
Setup
Memory card
Timer
TVG/Photo
- -
Timer
Sleep
Timer 1
Timer 2
Timer 3
Timer 4
Timer 5
60
Sleep
Sleep
310 - 1
EVR FRI
10:00 AM
11:00 AM
On
Timer 1
CH
Day
On time
Off time
Set
SUN/MON/TUE/WED/THU/FRI/SAT/
MON-FRI/SAT-SUN/DAILY/EVR SUN/
EVR MON/EVR TUE/EVR WED/EVR THU/
EVR FRI/ EVR SAT
Using Timer
Select “Timer”
Select the timer to set
3
2
Set the timer
4
select
Display menu
1
select
next
next
select
Turns Off automatically Sleep
Turns On/Off automatically
(5 timers can be set.)
Timer 1
Timer 5
~
select
set
Select the channel CH
Select the day Day
The time to turn On On time
The time to turn Off Off time
Timer setting (On/Off) Set
Ŷ
To set “Sleep” (Off Timer)
Press to set unit to shut itself off after a preselected amount of time.
Ŷ
Press to exit
Ŷ
Press to return
to the previous
screen
Note
•
The TV automatically
turns Off after 90
minutes when turned
On by the Timer.
This operation will be
cancelled if the Off
time is selected or if a
key is pressed.
The TV can automatically turn On/Off at the designated date and time.
•
The Clock must be set before On time/Off time settings. (p. 11)
•
0/30/60/90 (minutes)
Ŷ
To set “Timer 1-5” (On/Off Timer)
Select the item and set
Operating Peripheral Equipment
You can operate other manufacturers’ components using this TV’s remote control.
4
1
2
Press both buttons simultaneously
for more than 3 seconds.
•
Release the buttons when the equipment selection
buttons start flashing.
+
3
5
Caution
•
Registration will fail if the wrong code is input or it takes more than 30 seconds to register.
Select the equipment
with the equipment selection button
•
The selected button remains lit (other buttons are not
lit).
Connect the external devices to the TV and
turn Off the external equipment
Input the equipment’s 4-digit remote
control code
(p. 47-48)
Confirm the equipment with the
remote control
•
The external equipment turns On.
Ŷ
If the equipment does not operate with
remote control
•
When your equipment has a single code
Input the remote control code again
•
When your equipment has multiple codes
Change the code with above and test again
(p. 47-48)
After step above, change the code and
test
store
Operate the equipment with the
remote control (p. 46)
•
Repeat until the code is found
•
It may take many attempts before the correct
code is found
When the correct code is found
change
To find a code not listed in the code list
This procedure searches all codes and is called the “sequence method.”