- 18 -
Replacing carbon brushes
Keep the carbon brushes clean and
free to slip in the holders. When it is
less than 5 mm shorter both carbon
brushes should be replaced at the
same time. Use only identical carbon
brushes.
Carbon brush
Brush cap
Screw driver
Use a screwdriver to remove the caps.
Take out the worn carbon brushes,
insert the new ones and secure the
brush caps.
To maintain product SAFETY and
RELIABILITY, repairs, any other
maintenance or adjustment should be
performed by Panasonic Authorized or
Factory Service Centers, always using
Panasonic replacement parts.
V. MAINTENANCE
• Use only a dry, soft cloth for wiping the
unit. Do not use a damp cloth, thinner,
benzine, or other volatile solvents for
cleaning.
• In the event that the inside of the tool or
battery pack is exposed to water, drain
and allow to dry as soon as possible.
Carefully remove any dust or iron
filings that collect inside the tool. If you
experience any problems operating the
tool, consult with a repair shop.
VI. ACCESSORIES
CAUTION
• The use of any accessories not
specified in this manual may
result in fire, electric shock, or
personal injury. Use recommended
accessories only.
• Your tool is supplied with a guard
for use with a grinding disc. A cut-off
disc can also be used with a cut-off
disc guard.
Grinding Disc
• Rated speed: greater than or equal
to 72m/min
• Max. wheel diameter:
Φ
125mm
• Hole diameter:
Φ
22mm
• Max. thickness: 6mm
Grinding Disc Guard
• WEY46A2K3747
Cut-off Disc
• Rated speed: greater than or equal
to 72m/min
• Max. wheel diameter:
Φ
125mm
• Hole diameter:
Φ
22mm
• Flat disc only
Cut-off Disc Guard (For cut-off disc)
• WEY46A2K3137
Disc Flange
• EY4640K1168
Clamp Nut
• WEY4640K1178
01̲Eng̲EY46A2(EU).indd 18
2014/07/03 10:11:03
