Panametrics HydroProII, User Manual

Page: 72 / 104

Appendix A. HygroPro
II
HART
®
Field Device Specification
60 HygroPro
II
User's Manual
Command-Specific Response Codes
A.9.19 Command 158(0x9E): Set Saturation Table Number of Points
This command set the number of points for the saturation table.
Request Data Bytes
Response Data Bytes
Command-Specific Response Codes
A.9.20 Command 159 (0x9F): Read Saturation Table Number of Points
This command reads the number of saturation table points.
Request Data Bytes
8 ~ 11 Float High End mV
12 ~ 15 Float High End PSIg
Code Class Description
0 Success No Command-Specific Errors
1-127 Undefined
Byte Format Description
0 Unsigned-8 Number of Saturation Table Points
Byte Format Description
0 Unsigned-8 Number of Saturation Table Points
Code Class Description
0 Success No Command-Specific Errors
1 Error Number of points out of range.
2-4 Undefined
5 Error Too Few Data Bytes Received
6 Error Device-Specific Command Error
7 Error In Write Protect Mode
8-15 Undefined
16 Error Access Restricted
8-127 Undefined
Byte Format Description
None