24
3.5.4 Other alarm
Fig4-26 other alarm
Step1: enter into system configuration
Æ
other alarm; refer to Fig 4-26:
Step2: select a hard disk in the pull down list box, when the disk capacity is lower than that value, there will
appear some text information on the lower right of the live image.
Step3: click “default” button to resort default setting; click “apply” button to save the setting; click “exit”
button to exit current interface.
3.5.5 Alarm out
Alarm out includes three sub menus: alarm out, schedule and buzzer
①
Alarm out
Step1: enter into system configuration
Æ
alarm out; refer to Fig 4-27:
Fig 4-27 system configuration-alarm out
Step2: in this interface, set relay alarm out name, select hold time which means the interval time between
the two adjacent alarms.
Step3: user can setup all channels with same parameters, tick off “all”, then to do relevant setup.
Step4: click “default” button to resort default setting; click “apply” button to save the setting; click “exit”
button to exit current interface.
②
Schedule
Step1: enter into system configuration
Æ
schedule;
Step2: the setup steps of alarm out schedule are familiar with schedule; user can refer to 4.4.1 Schedule
for details.
Note: the default schedule of motion detection is full-selected, that is, the color of schedule setting
interface is blue.
③
Buzzer
Step1: enter into system configuration
Æ
buzzer; (if here sets is off, all event without buzzer)
Step2: tick off Buzzer, set buzzer alarm hold time
3.6
Network configuration
Network configuration includes two submenus: network and network stream.
