© Pan Acoustics GmbH
V 1.0
Page 18 of 24
Manual
Step 1:
Insert the stripped wires into pin 4 and pin 5 of
the connection terminal. To do this, open the
screw blocks with a screwdriver. After insert-
ing the wires, close the screw blocks again and
hand-tighten them with a torque of 10 Nm so
that the wires cannot slip out.
The wires of the connection cable must be
fi tted with wire end ferrules.
NOTICE
8.2.2.4. Power tapping 12.5%
Step 2:
Insert the connection terminal with the cable
into the 5-pin connector on the loudspeaker.
