PALSON 30128, Operating Instructions Manual

Page: 10 / 28

10
Charging
1. Charge the shaver in a place where the temperature is higher than 0º and lower
than 40º.
2. The nominal input voltage of the shaver is 100V-240V. Do not charge the shaver
for too long as this could shorten its useful life.
3. Connect the electric cable to the shaver and plug the other end into an AC
output. The five battery indicators will glow one by one while it is being charged.
When the appliance has been fully charged, the five green lights will glow. You
can charge the shaver complete in 1-2 hours (depending on use). A full charge
gives you approximately 45 minutes of shaving time.
To use the shaver
1. Press the I/O button to turn on the shaver.
2. Hold the shaver at a right angle (90º) to the skin. Stretch the skin with your free
hand and move the shaver upwards and backwards, following the direction of
the stubble. The shaver works better on dry skin. Your skin and beard may need
2-3 weeks to get used to the shaver.
3. Turn off the shaver.
4. Replace the protective cover.
It is advisable to change the shaver head each year to ensure the best shaving (use
only original parts).
Cleaning the shaver
1. Frequent cleaning will keep the shaver in good condition and ensure good
shaving.
2.
WarNiNg
- to prevent electrocution or physical damage, disconnect the electric
cable from the shaver before cleaning it.
head axle
Clean the shaver head every week.
1. Clean the head axle with the brush.
2. Press the head release button and the shaver head will automatically open.
Clean the internal blades every two months
1. Press the head release button and protective sheet will automatically open.
2. Remove the three round blades as indicated below:
3. Remove the internal blades from the shaver heads and clean them thoroughly.
4. Replace the protective cover.
GB