Install the M-300 and M-700 Appliance
holes, and then release the buttons to secure the rails to the rack. The following image shows
the right side of the rack if you are facing the front of the rack.
To remove the outer rails from the rack, you must pull the release clips located at the
front and back end of each rail assembly to release the rails from the rack.
STEP 3 |
Install the firewall in to the equipment rack by sliding the inner-rails in to the outer rack-
mount rails until the appliance stops (about halfway in to the rack). Push the inner-rail release
clips on each side of the two rails (push the left clip up and the right clip down) to release
M-300 and M-700 Appliance Hardware Reference
27
©
2023 Palo Alto Networks, Inc.