PAGE | 13
Figure 9 - Powering all stacked boards via the Arduino MKR
The EmStat4M HR is designed for higher currents and is protected against over-current and
high temperature. To prevent entering these overload conditions make sure that the setup has
good airflow. When the EmStat4M is used in a closed environment (housing) forced air-cooling
(fan) is strongly recommended.
Note: MethodSCRIPT error 0x0032 will be thrown in case of an overload condition
See
https://www.palmsens.com/wp-content/uploads/2022/01/MethodSCRIPT-v1_3.pdf
Section 14
“
Error handling
”
To do valid measurements on an electrochemical cell, the RE, WE and CE of the EmStat4M
module and the Sense lead (for the EmStat4M HR) need to be connected.
