palmiye Skyroof Plus Hanging, Installation Manual

Page: 17 / 36

17
Using a small screwdriver loosen the screws on the reverse side of the remote control and
remove the back cover.
Replace the battery with one 2430 Lithium 3V Battery.
5.5. Programming
5.5.1. Actuators
Step 1: Select desired channel on your remote
Step 2: Press the “PROGRAMMING” button. (~5sec.)
Step 3: Press “PROG” button on your remote control.
5.5.2. Perimeter and / or Panel lights
Step 1: Select desired channel on your remote
Step 2: Press “UP” and “DOWN” button simultaneously. Both lighting system will TURN ON.
Step 3: Press “PROG” button on your remote control.
IMPORTANT NOTE: At this stage, if there is only one of these systems, the lighting
programming process is completed.
However, if there is both perimeter and panel lighting, both lighting systems are programmed
in only one channel. It means both light systems will TURN ON at same time.
Also, you can control as separately,
5.5.2.1. Separation of lighting systems * (Only if Plus product has both perimeter and panel
lighting)
Step 1: Cut off the power entering the control box and for 10sec. supply a power again after
waiting,
5.4. Replacing The Battery