ADJUST MITRE GAUGE
Refer to Figure 14
• Loosen the lock handle in order to allow the mitre body to rotate
freely. Position the mitre body at 90°, so that the positive detent
secures its position. Tighten the lock handle in order to hold the
mitre body in position.
• If the pointer requires adjustment, loosen the two screws (1)
under the pointer using a screwdriver. Adjust the pointer to 90°
on the scale, and then firmly tighten both adjusting screws (1).
INSTALL THE RIGHT EXTENSION TABLE
Refer to Figure 15
• Insert the table extension poles (1) into the two matching holes
located under the work table.
• Slide the right table extension (2) toward the work table until it
rests against the work table.
• Thread the locking knobs (3) into the holes under the work table
and tighten them.
• Thread the two stop screws (4) into the holes located on the end
of the table extension poles (1) and tighten them.
NOTE:
Make sure the front mounting tube has the measuring scale
visible from the front of the saw.
15
PALMGREN Operating Manual & Parts List
9683408
MITRE GAUGE INSTALLATION AND USE
Refer to Figure 13a-13c
INSTALLATION:
The mitre gauge (1) can be installed on each mitre gauge groove
(2) on either side of blade.
• Slide the two screws (3) of locking knobs (4) to the slot of the
parallel profile (5).
• Slide the two screws of locking knobs (4) to match the slot of the
mitre gauge.
• Fit the two screws into the slot of mitre gauge and secure with the
locking knobs (4).
• Slide the guide rail (6) of the mitre gauge (1) into one of the guide
grooves (2) of the saw table intended for this purpose.
USE:
The mitre gauge provides accuracy in angled cuts. For very close
tolerances, test cuts are recommended.
There are two mitre gauge grooves, one on either side of blade.
When making a 90° cross cut, use either mitre gauge groove. When
making a bevelled cross cut (blade tilted in relation to working
table, mitre gauge should be located in groove on right so that
blade is tilted away from mitre gauge and hands.
The mitre gauge can be turned 60° to the left or right.
• Loosen lock knob (1) turning it counterclockwise.
• With mitre gauge in mitre gauge groove, rotate mitre gauge (2)
until desired angle is reached on scale (3).
• Retighten lock knob (1) turning it clockwise.
Figure 13a
Figure 13b
Figure 13c
Figure 14
2
5
3
4
1
6
1
2
1
2
3
1
Summary of Contents for 9683408
