OPERATION AND MAINTENANCE
32806 & 34105
•
Adjustment of the worm and gear requires removal of
the top (Ref. No. 1). First loosen the two locking clamp
screws (Ref. No. 14) located on the outside rim to disen-
gage the internal locking clamps (Ref. No. 16). To remove
the top, take out the four socket head cap screws (Ref.
No. 20) near the center. The top will then lift off. Be sure
to lift the top straight up because of the snug fit of the
two dowel pins (Ref. No. 15). Make a mark so that the
tabletop and dowels will be replaced in the same loca-
tion as originally assembled.
•
To adjust the worm and gear loosen the two screws (Ref.
No. 21) holding the worm shaft bracket (Ref. No. 5) and
make adjustment with the back-up adjusting screw (Ref.
No. 27) in the rim of the top slide casting. Tighten the
bracket hold-down screws after adjustment is made and
replace the top.
•
Depending on usage, the worm and gear will require
occasional lubrication. The worm gear (Ref. No. 4) can be
lubricated from the underside by turning the table on its
side. We recommend No. 2 grease to lubricate the worm
and worm gear.
•
Indexing table tops are graduated the full 360 degrees ,
with the 0° marking to coincide with the axis of the T-
Slots. The brass pointer (Ref. No. 13) has a slotted hole to
provide for line up at start of work operation.
•
The graduated dial collars (Ref. No. 10) on the index shaft
are calibrated for direct reading at increments of 1/20
degrees (3 minutes).
•
Periodically wipe table with a rust-preventative oil.
WARRANTY
Palmgren warrants their products to be free of deficiency in material or workmanship. The duration of this warranty is
expressively limited to one year parts and labor unless otherwise noted beginning from the date of delivery to the original
user. The following Palmgren products carry the following warranties on parts with a 1 year warranty on labor:
The obligation of Palmgren is limited solely to the repair or replacement, at our option, at its factory or authorized repair
agent of any part that should prove deficient. The warranty does not cover expendable and/or wear parts (i.e. v-belts, coated
abrasives), damage to tools arising from alteration, abuse or use other than their intended purpose, packing and freight.
Purchaser must lubricate and maintain the product under normal operating conditions at all times. Proper use and care
instructions are provided in the operator’s manual. Failure to follow these instructions will void the warranty.
This warranty is the purchaser’s exclusive remedy against Palmgren for any deficiency in its products. Under no circumstances
is Palmgren liable for any direct, indirect, incidental, special or consequential damages including lost profits in any way related
to the use or inability to use our products. This warranty gives you specific legal rights which may vary from state to state.
SERVICE & REPAIR
1. If a Palmgren product requires a repair or warranty service
DO NOT
return the product to the place of purchase.
2. All warranty related work must be evaluated and approved by Palmgren.
3. Prior to returning any item the user must obtain factory approval and a valid RGA number.
4. For instructions and RGA number call toll free (800) 621-6145.
•
USA Machine vises – Lifetime
•
Imported Machine vises – 2 years
•
Bench vises – 2 years
•
Positioning tables – 2 years
•
Bench grinders & buffers – 3 years
•
Tapping machines – 2 years
•
Drilling machines – 2 years
•
Finishing machines – 2 years
•
Band saws – 2 years
•
Work stands – 2 years
