15
Step 3: Switching on the Correlator
Switch the correlator on by pressing the On/Off switch momentarily. A number of system
tests are carried out on power up to ensure the correlator is fully functional. After a few
seconds the main correlation screen will appear on the display as shown below. Note, this is
the default screen on start-up to enable the operator to start correlating immediately. The
Main Menu screen is accessed by pressing Cancel.
To switch the correlator off
, press the On/Off button and select 2, to switch off
To turn off the display only
, press the On/Off button and select 1, to put into standby. (If
the correlator is not then used for 2 hours it will switch off). To reactivate the screen, press the
On/Off button again.
The top menu bar on the correlate screen shows information for each sensor by displaying in
the relevant colour (except Yellow appears black)
Indicates radio signal
is transmitting
Indicates radio
power setting
Indicates sensor
connected to Out
Station
Indicates battery
charge level
Date and time
In this situation the Red and
Blue sensors are being used,
they have communication
with the Base unit ok, using
low power
Space where Yellow
Sensor information
would be displayed if
attached
Correlating function options
Control unit
information
