7
General Work Products LLC | 6000 Jefferson Hwy | Harahan, LA 70123
www.PalmerSafetyUS.com
•Fall Protection •Training •Netting •PPE
®
Components and Specifications
Components made from some or all of the following: galvanized steel and stainless steel.
Components Included:
A. 6’ Vinyl coated cable choker – Pieces (2)
B. Assembled 3/8” Cable HLL System with pull loop
on one end – Pieces (1)
C. 3/8” Adjustable cable clamps – Pieces (3)
D. Military grade backpack
Tools Needed:
1.) 5/16” wrench
2.) 3/4” wrench
Requirements:
1.) Two (2) 5,000 lb. (HLL Compatible) anchor points
2.) Weight Min / Max (120 lbs. – 420 lbs.)
3.) Maximum Users – Two (2)
4.) 0 – 60’ (1 Absorber)
5.) 0 – 100’ (2 Absorbers)
Installation and Use
1.) Confirm with Competent Person that anchor points are rated for 5,000 lbs.
2.) Measure distance between anchor points. Set the clamps to measured distance.
3.) Make sure turnbuckle is all the way extended.
4.) Attach carabiner on pull loop end to first anchor point.
5.) Attach carabiner on end with cable clamps to second anchor point.
6.) Tighten turnbuckle until line has between 2 - 6 inches of slack.
Adjustment
Efficiency ratings for wire rope end terminations are based upon the catalog breaking strength of wire rope. The efficiency
rating of a properly prepared loop or thimble-eye termination for clip sizes 1/8” through 7/8” is 80%, and for 1” through
3-1/2” is 90%.
WARNING:
Prepare wire rope end termination only as instructed. DO NOT use vinyl/plastic coated wire rope. Apply
first load to test the assembly. This load should be of equal or greater weight than loads expected in use.
A
B
D
C
