General safety information
2
Disconnect power at
the service breaker before installing or
servicing. Full pole disconnection device
must be incorporated in the fixed wiring
This product is
intended for installation by a qualified
service person. Use 2.0 mm² (AWG NO.14)
solid conductor for wiring.
All units must be
supplied with a 3-wire service. The
ground wire must be connected to the
dryer's backplate.
Failure to properly
ground unit could result in severe
electrical shock and/or death.
【
Type Y attachment
】
If the power supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a qualified person in order to avoid a hazard. Disconnect
the fixed wiring only in accordance with the wiring rules.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
N
OTE: We do not recommend installing this dryer above a basin. If you are installing
this dryer above a basin, please make sure that reflection won’t occur.
in accordance with the wiring rules.
Circuit Diagram
Motor
W
ith
T
her
mal Switc
h
Circuit Board Module
SENSOR
Transistor
Power Switch
Hea
ter W
ith
T
her
mo-fuse
Thermostat
G
N
L
Brown
Blue
G/Y
1 2 3 4 5
MO2 HE2
N
L
MO1 HE1
VR
Red (110-120~Vac)
Brown(220-240~Vac)
Black
Black
White(110-120~Vac)
Blue(220-240~Vac)
Operating Instructions and Parts Manual
Hand Dryer
Surface-mounted high speed hand dryer
BERLS.COM
(704) 937-2673
129 Oakpark Drive, Unit A, Mooresville, NC 28115
COMMERCIAL
SUPPLY
