Ending the work
Always remove discs or brushes after work.
Always disconnect the power cord after work or when
leaving the machine.
Maintenance and Service
Maintenance and Cleaning
► Before any work on the machine itself, pull
the mains plug.
► For safe and proper working, always keep
the machine and ventilation slots clean.
► Clean the cooling fins of the motor and electronic
system on a regular basis.
Once work has been completed, the clamping devices
must be disassembled and the machine cleaned
The machine must then be sent to an after-sales
service agent. Addresses are listed in the Section
“After- sales service and customer assistance”.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Pallmann GmbH power tools.
In all correspondence and spare parts orders,
please always include the article number
specified on the type plate of the machine.
Trouble shooting
Functioning of the electronic speed control:
By turning the control, the target speed can be set from
50 to 400 rpm. When under extreme load, e.g. when
using abrasive gauze on cork with additional weight,
the machine reduces its speed automatically.
The machine switches off automatically in the
event of overloading.
The LED (18) flashes in varying intervals.
... Overload:
The machine has been extremely overloaded.
The machine can be restarted after some seconds.
... Electronics overheated:
The machine can be restarted when the LED stops
flashing. This indicates that the electronics have
cooled and the machine is operational.
...Motor overheated:
The machine can be restarted when the LED stops
flashing. This indicates that the motor has cooled and
the machine is operational
To remove load from the machine, detach the additional
weight and/or reduce the speed.
Trouble
Eventual cause
Elimination
Machine does
Wrong speed
Speed frequency must selct
not run smoothly
frequency
in correspondending with the
floor, the tools and the
abraisives
Machine does not start Power supply
Have machine
Disconnected
repaired by a qualified
blown fuse
electrician,
defective cable or plug
resp. change parts
Machine does not start Machine overloaded
Take off additional weight.
Machine does not start Machine overloaded
Tilt the machine over the
transportation wheels.
The plate is unloaded.
Start the machine and
lower it slowly on the floor
21
03/2015
Einscheibenschleifmaschine Spider, 230V,
#78319
