![background image](http://html1.mh-extra.com/html/pallmann/cobra-classic/cobra-classic_translation-of-the-original-operating-instructions_3329222008.webp)
8
PALLMANN GmbH l Ein Unternehmen der Uzin Utz AG | Im Kreuz 6 | 97076 Würzburg | T49 931 27964-0 | T49 931 27964-50 I www.pallmann.net
5 Assembly of the machine
5.1 Installing the guide tube
Note!
The Cobra Classic is delivered with the guide tube (1) removed.
Caution! Injury to the operator or other persons could occur or damage could occur if the machine
starts up unintentionally. Disconnect the machine from the power supply before working
on the machine!
Instructions:
1. Insert the guide tube (1) into the guide tube support (7). The curved section of the tube must
face toward the motor. Clamp the guide tube by means of the clamping lever (6) located on
the guide tube support.
2. Fit the connector (8) into the both screws of th pull rod
3. Move the main lifting lever (2) into the rear position to raise the sanding drum from the fl oor.
4. Tighten both wing nuts
5.2 Installing the motor:
Installation of the motor is performed in the opposite order to the steps described in Chapter 6.2
Removing the motor.