PTV 35/44/55/66 Installation Manual
Rev. 1.1
46
Do not route hoses, wires, harnesses, and cables near, around, or in contact with sharp edges, air
lines, vehicle electrical, exhaust system, fuel lines, or liftgate moving parts.
2. Route Hoses and Control Harness: At the bottom of the curb side column of the liftgate the controls wire
harness can be found. Position hoses opposite to each other.
3/8” hoses should have one male and
one female exposed at each end. Position the ¼
” hoses in the same manner, one male and one
female at each end,
Fig.13
. Route the control wire harness and the all hoses through the hat section(s)
and out towards the hydraulic enclosure.
3/8" Male
3/8" Female
1/4" Female
1/4" Male
J30 Control
Harness
Curb Side
Column
Control
Harness
Always add a radius to
the control and light
harnesses routing
to avoid any sharp
edges
Tail Lights
Harness
Fig. 13
