Ohjekirja Palax combi M 2004.1 En
26
33
A
34
35
A
B
Replacement of the V-belts, angle gear, Figure 33
Slacken the V-belts using the emergency stop lever.
Remove the sawdust trough cover (17 mm spanner).
Remove the side plate of the saw-blade cover (13 mm
spanner).
Place a pin, about 12 mm in diameter, into the hole in the
belt pulley to prevent the blade from rotating.
Unscrew the saw-blade nut (right-hand thread, 36 mm
spanner).
The thread on the nut is M 24 x 2.
Remove the blade.
Loosen the nuts on the angular gear bed.
Replace the old belts with the new ones, type SPA 1357,
two pcs.
Tighten the V-belts using the emergency stop lever.
When tightening the V-belts, follow the instructions in
Chapter 8.2.
Carefully clean the surfaces of the flanges before re-installation of the blade.
Because new belts tend to stretch slightly, remember to check the tightness of the V-
belts after a few hours of operation.
7.4 Changing the oil in the angular gear
Open the oil plug C (Figure 32) and drain the used oil, e.g. by means of suction
drainage.
Fill up with new oil, about 0.5 litres.
SAE 80 is used for tractor-powered machines.
7.5 Lubricating the machine, Fig 34
If the machine is left unused for a longer period of
time, lubricate the shaft bearings A (Figure 24) with
roller-bearing lubricant at the end of the operating
season.
If the machine is used regularly, lubricate the bearings
once a week.
Lubricate daily with oil the moving joints, log-stop,
table feet and the support rollers.
7.6 Adjustment of the conveyor belt
3.5 and 4.5 m models
The conveyor belt is installed and pre-adjusted at the factory.
Tightening the conveyor belt, Figure 35
Loosen the lower nuts A (Figure 35).
Tighten the upper nuts B.
Adjust both adjustment screws as much as is
necessary to prevent the belt from pulling to the
either side.
The tightness is suitable if you are able to lift the
belt about 5 cm with your hand.
