22
MODEL T6
HARLEY POWER BOX RAKE®
MAINTENANCE
To replace, reverse the procedure. Be sure all parts and wear surfaces are thoroughly clean
and in good condition. Be sure O-ring is also in good condition.
When replacing bearing, first put O-ring on bearing. Apply a coat of grease on O-ring. Slide
bearing in and apply moderate pressure on bearing so O-ring will seat and spread slightly, thus
keeping the oil in chain case from escaping through the bearing.
Right Roller Bearing
. Remove the hex bolt and bearing cap from outside of bearing.
2. Loosen bolt on the bearing tube that holds cartridge bearing in place. Pry bearing tube
apart to free bearing assembly.
Have roller blocked up or supported. Pry bearing off of shaft and out of
bearing holder.
To Replace, reverse the procedure. Be sure all parts and wear surfaces
are thoroughly clean and in good condition.
Roller Replacement
It will be necessary to have a lifting device or additional help while removing and replacing the
roller. The roller weighs approximately 50 lbs.
. Remove upper and lower chain case covers.
2. Remove sprocket tension spring and drive chain.
3. Remove lower sprocket by removing cotter pin, slotted nut, and washers.
4. Remove the sleeve behind the sprocket you just removed.
Have the roller blocked up or supported.
5. Remove the two bolts holding chain case to frame and slide chain case off of roller shaft.
The roller bearing will stay in the chain case.
If chain case bearing is also being replaced, see “Left Roller Bearing”
on page 21.
6. Loosen the bolt on the bearing tube of the non-drive end, sliding roller and bearing out of
frame.
7. Remove hex bolt, bearing cap, bearing, and protective collar from roller.
8. On roller to be installed, place machine bushing and protective collar against end plate of
roller.
9. Place bearing and bearing cap on roller.
0. Clamp in place with hex bolt and lock washer into end of roller shaft.
. Slide roller and bearing into bearing tube on non-drive end of frame. Do not tighten bear-
ing tube at this time.
2. Place machine bushing, protective collar, and O-ring from splined end of removed roller to
replacement roller. Check O-ring for cuts or nicks.
3. Apply sealant to bearing area of shaft.
NOTICE
NOTICE
NOTICE
NOTICE
Summary of Contents for HARLEY POWER BOX RAKE T6
