RSB-KIT INSTALLATION MANUAL
4 Broadband Software Configuration
The configuration on the SW8-GBV is fixed and there are only a few settings to the RT-50V Router
configuration that may be needed before the router/switch kit is operational. The first router configuration
is to setup your broadband internet connection. To do this, determine the type of internet service you have.
There are three types of internet connections that are supported by the RT-50V:
1)
DHCP
(Typically used by cable companies and DSL basic service)
2)
Static IP
(Fixed Public IP address mostly used by Business Class Broadband services)
3)
PPPoE
(Used by DSL companies such as AT&T)
Determine the type of internet connection from your ISP, and then follow one of the three instruction sets below
to connect the RT-50V to the internet.
4.1 DHCP Configuration
There are no configuration changes necessary if the internet service provider is using DHCP and you do not
wish to open network ports to the public internet or use SSL virtual private network (VPN).
Power down the internet provider supplied device and leave it powered down for one minute. Plug the
Ethernet cable from the ISP device into the “WAN1” port on the RT-50V Router. Power up the internet
provider supplied device, wait one minute then power on the Router.
25
Summary of Contents for RSB-KIT
Page 1: ...RSB KIT Preconfigured Audio Video Bridging System Installation Manual Version 2 0...
Page 50: ......
Page 51: ......