PairGain T1L2F10A, Manual

Page: 23 / 76

150-231-185-05, Revision 05 Provisioning
HLU-231 List 8E September 13, 1999 15
Selecting a Maintenance Terminal Function
To perform a function within the Maintenance Terminal screens, you can:
• Press the key indicated to the left of the selection.
• Press the letter in parenthesis for the parameter to be changed.
System Spans
As shown in Figure 4 , the HLU can support up to four doublers with five HDSL spans. The Span Status,
Performance Data, and Performance History may display as many five screens to depict an HLU-231 List 8E
system.
Figure 4. System Spans
U
SING THE
M
AINTENANCE
T
ERMINAL
S
CREENS
View Span Status Screen
The View Span Status option allows you to view up to five system status screens that provide information about
the HDSL Loop 1, HDSL Loop 2, and the DS1. For doubler applications, the available Span Status screens depend
on whether the system includes one, two, three, or four doublers.
Press from the Maintenance Terminal Main Menu to open the Span Status screen ( Figure 5 on page 16 ). If no
doubler (HDU) is present, the screen reports span status for the subscriber lines between the HLU and the HRU.
If there are additional doublers, the Span Status screen reports status on each span. Figure 6 on page 16 shows
status between HDU4 and the HRU in a system with four doublers. See Table 5 on page 17 for an explanation of
the Span Status fields.
From each Span Status screen you can:
•
Press to clear the cur (current), min (minimum) and max (maximum) numeric counts. This also clears the
Performance History and Performance Data screens.
•
Press to automatically update status screens. (Press again to turn off auto update.)
•
Press to update cur (current) values.
•
Press to view the next available span (for doubler applications).
•
Press to exit and return to the previous screen.
•
Press , , , , or to select a specific span (for doubler applications).
$
&
$ $
8
6
(
4 5 6 7 8