Maintenance
150-388-125-01, Revision 01
20
September 15, 1998
HLU-388 List 2E
Update the HRU Time and Date
For HRUs with software version 6.4 or higher, or HRUs List 6 or higher, the remote unit date and time is set by
using this option. To update the remote, do one of the following:
•
Press
to update the HRU to the same date and time set for the HLU-388.
•
Press
. (The remote unit is not updated.)
S
YSTEM
S
ETTINGS
The options set from the System Settings menu are the same as the options set through the HLU-388 front panel
MODE and SEL buttons (except for Margin Alarm Threshold and DS0 Blocking, which can only be set at this
screen). Refer to
for a listing of system setting options.
Press
from the Maintenance Terminal Main Menu to open the System Settings menu (
).
Figure 11.
System Settings Menu
To change any option:
1
Enter its character key, which is shown inside the parenthesis within each parameter description. This causes
the screen to refresh with the new settings.
2
After all parameters have been selected, press
to exit, then
to confirm. The newly selected parameters
are now activated.
All time information is lost when power is removed. The last date, however, is retained in
NVRAM and reappears when power is restored.
8
(17(5
&
SYSTEM SETTINGS
TIME: 12:46:06
DATE: 02/02/98 CIRCUIT ID#:
E(Q)UALIZATION
: 0
SMART-JACK (L)B
: ENABLED
(S)PECIAL LPBK
: GNLB
(P)OWER
: ENABLE
(Z)BTSI
: OFF
ES ALARM TH(R)ESH
: NONE
LOOPBACK (T)IMEOUT
: 60
(A)LARM
: DISABLE
(D)S1 LINE CODE
: AMI
(F)RAMING
: AUTO
AIS ON (H)DSL LOSW
: 2 LOOPS
AIS ON S(M)JK/NREM
: ENABLE
MAR(G)IN ALM THRES
: 4
DS0 (B)LOCKING: xx = Blocked Channels
01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
(E)xit
Enter the letter in parenthesis (X) to change any setting
(
&
