Pai Technology 62119, Instruction Manual

Page: 38 / 40

Re-sync
If you discover that the remote control indicator light or main
control block indicator light is con�nuously flashing quickly, or if the
remote control has no effect on the main control block, please
re-start the sync process.
1.Remove the ba�ery covers of the main control block and the
remote controller. Remove the ba�eries.
2.Re-install the ba�eries of the main control block according to the
posi�ve and nega�ve signs indicated inside the ba�ery compart-
ment, then do the same for the remote controller.
3.Press any bu�on on the remote control to start the sync. A�er the
sync is completed, the main control block and remote control
indicator lights will turn off automa�cally.
Remote control sync
Confirm the main control block is on, then press any bu�on on the
remote control. The remote control will sync with the main control
block.
A�er the sync is completed, the light on the remote control will
automa�cally go out. If the indicator light con�nues to flash a�er 30
seconds, it means sync was not successful. Please re-start the sync
process again. (See the “Re-start sync” page.)
*If the remote control isn’ t used in 20 minutes, the main control
block and remote control will go into standby mode. To use again,
please first press the bu�on under the main control block.
Remote controller light
Main control block light
Changing the ba�eries
Use a Phillips head screwdriver. Unscrew the
screws on the ba�ery cover counter-clockwise.
Remove the ba�ery cover and take out the
ba�eries.
Insert the ba�eries according to the posi�ve and
nega�ve signs inside the ba�ery compartment.
Replace the ba�ery compartment cover and screw
clockwise to fasten.
FAQs
Q: How do I determine if the car ba�ery is about to run
out?
A: The amount of ba�ery power le� can be determined
by the following situa�ons:
Situa�on 1: The car’s speed is no�ceably slow.
Situa�on 2: Its ac�ons are slow or unresponsive.
Situa�on 3: It won’t start up.
Q: What do I do if the car won’t start?
A. There are a few possibili�es. Confirm which one applies:
1. The ba�eries have no power. Please change them.
2. The ba�eries are installed backward. Please re-install them.
3. The on-off switch isn’t switched on. Please try turning it on again.
4. The first �me you used the remote control it wasn’t synced. Please sync it
according to the direc�ons.
5. You didn’t remove the transparent insula�on tape from the remote
control. Please remove it.
6. The wheels have been stopped up with a foreign object, e.g., hair or trash.
Please clear it away.
7. If you’re s�ll having issues, please contact Customer Service.