34
1. Please charge the product first before use it in the first time. Be sure to use the
charger meet the above requirement to charge, If you use it overseas, please first
understand whether the local voltage and charger is suitable for this product.
2. First turn off the product when charging. Connect the charger with the included
USB cable. Insert the charger to the power outlet and connect the product to the
USB charging cable.
3. The indicators of the product show a breathing light, indicating that charging is
under way. After the charging is completed, all the lights are on. At this point,
unplug the product from the USB cable and unplug the charger from the power
outlet. It is a normal phenomenon if the product and the charger are a little bit
hot.
4. It takes about 3 hours to charge full the product using the charger meeting the
requirement. The time may vary depend on specific circumstances.
Operation Mode
1、Working mode and switching: This product has three working modes, Clean,
Nourishing and Lifting. Press the power button for 3 seconds to turn on the device,
and choose the mode from the MODE key.
2、Clean mode: the "C " indicator light will be on, short press the power button
to switch between 3 speeds. At this time sonic vibration, hot
compress and ion export function will be synchronous. For this mode, it is necessary
cosmetic cotton pad and your usual make-up remover. A device off, remove the
plastic ring from the device, insert the cotton pad, close with the plastic ring.Be
careful to secure the ring firmly over the cotton. Put the make-up remover on top of
the cotton, switch on the device, select mode C and the frequency you prefer. Start
cleansing, making slow, circular movements all over the face. Properly wet the
cotton pad for the device to work correctly.
3、Nourishing mode: the "N" indicator light will be on, as before choose the speed. At
this time sonic vibration, hot compress, electroporation, LED red will be synchronous.
This mode can be used together with a fabric face mask, serum or cream. First apply
the product (mask, cream, serum) to the face, then pass the device over it. The
device should come into direct contact with the skin. Make slow, circular movements
all over the face.
4、Lifting mode: the " L " indicator light will be on, short press the power button
can be switched between three levels. At this time sonic vibration, hot
compress , micro-current massage will be synchronous, LED red and blue light
alternately auxiliary. This mode is recommended in conjunction with the use of a
moisturising or anti-ageing cream to facilitate use and gliding of the device over the
skin. Perform stretching movements from the inside of the face outwards. This will
provide a toning massage to the skin of the face and neck.
5、Start and pause: The product adopts intelligent contact control switch. When
the electrode is held in hand and the head of the product touches the skin, the
function is activated. When the head of the product leaves the skin, the
function is suspended.
6、 The device has an intelligent pre-set timer. At the end of the recommended time
for each mode, the device stops. 3 minutes for cleansing C, 3 minutes for nourishing
N and 8 minutes for lifting massage L. If you wish, you can end the treatment earlier,
you do not have to wait for the end of the time. An acoustic beep sounds during use,
which is useful if you decide to work on the chin, after the beep you move to the
cheeks, after the beep to the forehead and so on. If you are working with the device
rotated freely over your face, you can ignore the beep.
