PACOM KRT01, User Manual

Page: 13 / 22

--Taking Temperature in Surface Temperature Mode (Direct Mode)
1. Setup the measurement mode to “Surface mode” (the setup
step see the above “2) Function Setup mode”;
2. Aim the probe tip at the object which will be measured.
3. Press [Power/Scan] button, then the measurement completed.
It will show the measurement data after a “bi” sound.
4. If the measured temperature is higher than 100℃ , display “Hi”.
If the measured temperature is below 0℃,display “Lo”.
5）Automatic shutdown
If you do nothing after the temperature measurement completed
and 15 seconds later, the thermometer will automatically
shutdown.
6) Memory function
In the power-on state, press the Up/Down button into memory
query mode, the LCD will be showing the recorded values or “ ----“
symbol if not record accompanied with memory M symbol. The
KRT01 can restore up to 99 sets data. the query interface can
display memory serial number, body mode and recorded tempera-
ture values.
Remark: The temperature result of surface mode can not be saved.
And the abnormal body temperature result can not be saved too
(such as Lo, Err or Hi).
7)
Backlight function
The backlight will be according to the different measuring
temperature to lighting different color. The detailed as below
table:
TEMPERATURE TAKING HINTS
- For heat-insulated object, please don’t measure the
surface.
- For hot liquid, please do not directly measure the
surface， because the hot steam fog can condense in the
sensor lens and cause the measurement deviation.
Measuring temperature Backlight Lighting time
< 37.5
℃ Green backlight 7s
37.5 to 37.9
℃
Orange backlight 7s
≥
38.0 ℃ Red backlight 7s
Remarks: This specification of this table only for the factory default state. If the user into the setup
mode to setting the orange or red backing temperature, then will compliance with the setting result.
- 12 -