I
NSTALLATION
P
ACKET
L
IGHT
N
ETWORKS
PL-300
3.2
I
NSTALLATION AND
C
ONFIGURATION
M
ANUAL
C
ONFIDENTIAL AND
P
ROPRIETARY
I
NFORMATION
.
A
LL RIGHTS RESERVED
.
P
AGE
37
The following table provides information regarding the fiber and connector
specifications for the MNG port.
Table 23: MNG Port Specifications
Specification
Requirement
Fiber Type
Single mode
Fiber Size
2 mm optical fiber
Connector Type
LC
Port Type
Optical Supervisory Channel
2.3
Installing the PL-300 Unit
PL-300 units are intended for installation in 19-inch or 23-inch racks or placed on
desktops or shelves.
C
AUTION
:
Before installing a PL-300 unit, review the
2.3.1
Package Contents
The PL-300 package includes the following items:
•
PL-300 unit
•
Fiber tray
•
Kit for rack installation: 19", 23" (if ordered), or 600 mm ETSI (if ordered)
2.3.2
Optical Cable Handling Precautions
The following are the optical cable handing precautions:
•
Make sure that all the optical connectors are closed at all times, either by the
appropriate protective caps or by the mating cable connector. Do not remove
the protective cap until an optical fiber is connected to the corresponding
connector, and immediately install a protective cap after a cable is
disconnected.
•
(Recommended) Before installing optical cables, thoroughly clean their
connectors using an approved cleaning kit.
•
When connecting optical cables, make sure to prevent cable twisting and
avoid sharp bends. Unless otherwise specified by the optical cable
manufacturer, the minimum fiber bending radius is 35 mm. Always leave
some slack, to prevent stress.
•
(Recommended) Install plastic supports on each cable connector. These
supports determine the fiber bending radius at the connector entry point and
also prevent stress at this point.
Summary of Contents for PL-300
