10. Lighting instructions
Caution
: The lid must be open when lighting the burner!
Do not stand with your face directly over the gas grill when lighting it.
Your gas grill will have following method of ignition:
Pilot Gas Control Ignition:
With all gas controls on the Gas grill in the “OFF” position, turn the gas cylinder
valve to the on position at the regulator. To create a spark you must push the control
knob in (A) and hold in this position for 3-5 seconds to allow gas flow and then turn
anticlockwise to” HIGH” (B). It can spark to the burner lighting tube (C). You will
hear a “snap” from the igniter and you will also see a 3”-5” orange flame coming
from the burner lighting tube at the left side of the burner (D).
Continue to hold the burner control knob in for two seconds after the “snap”, this will
allow gas to flow completely down the burner tube (E) and insure ignition.
When the burner is alight, adjacent burners will cross light when their controls are
turned to “HIGH”
At “High” setting the burner flame should be approximately 12-20mm long with a
minimum of orange flame. Turn the gas control fully anticlockwise for minimum
setting.
Should you have any difficulty lighting your gas grill following the above steps,
contact your dealer for advice.
Warning
: If the burner still does not light ,turn the burner control knob
to” OFF” and wait 5 minutes to let the gas clear before lighting again.
Summary of Contents for M5 Mirage 3
