Pacifica M5 Mirage 3, Manual

Page: 17 / 24

Energy saving tips:
a) Reduce the opening time of the lid.
b) Turn the grill off as soon as cooking is completed.
c) Preheat the gas grill for 10 to 15 minutes only.
(Except for the first use)
d) Do not preheat longer then recommended.
e) Do not use a higher setting than required.
Connect the hose and regulator to the gas container at the right side of the gas
grill .Keeping in mind that the gas container must be kept away from heat and in a
safe position .The hose dimension is 8mm diameter.
7. Installation
After purchasing your gas bottle you will then be ready to set it up with your gas grill.
a) When changing the gas bottle which shall be carried out away from any
source of ignition. Position the gas bottle at the side of your gas grill, not
underneath, keeping in mind that the bottle must be kept away from heat and in a
safe position.
b) When ready to use your gas grill insert the regulator into the gas bottle valve and
tighten firmly.
The maximum length of hose shall not exceed 1.5m.
Warning: Before attempting to light your gas grill you must refer to your
lighting instructions and warning / safety points.
Check the hose before each use, searching for cracking, cuts or any abrasions. If the
hose is found to be faulty in any way do not attempt to use your gas grill.
When changing your gas bottle ensures that there are no sources of ignition close by
i.e. fires, cigarettes, naked flames etc. Make sure that the appliance is switched off.
Ensure that the hose is not subjected to twisting
which will affect the gas flow
when using your gas grill. Also the hose must not have undue tension and must not
touch any part of the gas grill which may be hot.
Please choose
flexible hose
whose heatproof higher than 80
℃
Every 2 years changing the flexible hose when the national conditions require it.
How to connect a gas bottle
a) Turn the orange cap so that the arrow is pointing to the gap in the shroud.
b) Remove the orange safety cap by pulling the lanyard out, then out. Do not use
tools. Leave the cap hanging.
c) Check that the black sealing washer is fitted inside the cylinder valve. Place the
regulator down over the valve with switch.
d) Turn the switch clockwise on gas bottle-then turn on the gas grill as instructed.